DIFFERENTIAL ADJUST WASHERS 16x13x0.1/0.2 mm (20pcs)
Se colocan entre el rodamiento del vaso del diferencial y la caja y se ponen indistintamente a un lado o otro dependiendo de las necesidades.
Incluye: 16X13x0.10 - 10 uds y 16X13X0.2 - 10 uds.
DRIVE SHAFT ADJUSTMENT WASHERS 8x10x0.1 (10pcs)
This is pack of 10 Ultimate Racing drive shaft shims. These are the small shims used to shim the space between the drive shaft and the wheel hub.
Its dimensions 8,1x10x0,1 mm allows adjusting perfectly the wheel hub tolerance without affecting the proper bearing function because it just lean on the internal part of the bearing.
DUAL LOCK FASTENER TAPE 15 cm
FLY WHEEL WASHER SPACER 7x10x0.5 (5pcs.)
This is a set of replacement clutch shims. This kit contains five 7x10x0.5 mm Stainless Steel shims. These adjstment shims are used for shimming 1/8th scale clutches. It is always a good idea to shim the clutch so that the bell has a little bit of play, but not too much.
HARD THREAD LOCK
Fija tornillos Soft de Ultimate Racing. Pegamento anaeróbico que se endurece cuando se pone entre dos piezas metálicas. El fija tornillos soft está diseñado para que sea fácil de aflojar.
LEXAN SCISSORS CURVED
M2 NYLON LOCKNUTS (10 pcs)
This is a pack of ten ylon Locknuts from Ultimate Racing. These are made of 12.9 steel which is the best grade you can use on your RC.
The Ultimate Racing Premium Nylon Locknuts are chromed finish which is an efficient protection against corrosion.
M2,5 NYLON LOCKNUTS (10 pcs)
This is a pack of ten ylon Locknuts from Ultimate Racing. These are made of 12.9 steel which is the best grade you can use on your RC.
The Ultimate Racing Premium Nylon Locknuts are chromed finish which is an efficient protection against corrosion.
M2,5x10mm CAP HEAD SCREWS (10 pcs)
M2,5x10mm FLAT HEAD SCREWS (10 pcs)
M2,5x12mm CAP HEAD SCREWS (10 pcs)
M2,5x16mm CAP HEAD SCREWS (10 pcs)
M2,5x16mm FLAT HEAD SCREWS (10 pcs)
M2,5x25mm CAP HEAD SCREWS (10 pcs)
M2,5x6mm FLAT HEAD SCREWS (10 pcs)
